TP-LINK TL-SG1024 Guide de l'utilisateur télécharger pdf (Page 3)

FCC STATEMENT

This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference

in which case the user will be required to correct the interference at his own expense.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference received, including interference that may

cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

CE Mark Warning

This is a class A product. In a domestic environment, this product may cause radio

interference, in which case the user may be required to take adequate measures.

Note:

As for TL-SG1008, a fuse resistor is used in the “F1” position on the PCB of the power

module. The fuse resistor should be used with the following type: 10ohm 2W@25℃.

1 2 3 4 5 6 7 8 ... 15 16

Pas de commentaire

TP-LINK TL-SG1024 Guide de l'utilisateur Page 3