TP-LINK TL-WA7510N Guide d'installation

1 Typical Network 1 Note The typical connection for TL-WA7510N is shown as above. Please make sure that the two CPEs are placed face to face;

10 The pigtail cable is used to change the N type port to RP-SMA type port. Login Appendix 1: External Antenna Installation

11 Click OK Configure the External Antenna A dialog box will prompt you for the User name and Password.Enter the default values and click OK.

12 Note T1. How do I restore my AP’s configuration to its factory default settings? T2. What can I do if I forget my password? 1) Restore

13 Click Change adapter settingsClick Properties Right-click Local Area Connection Double-click Internet Protocol Version 4 (TCP/IPv4)

14 ¾ For Windows XP OS Go to Start > Control Panel,you will then see the following page.Click Network and Internet Connections Select U

15 Double-click Internet Protocol (TCP/IP) Click Network Connections Click Properties Right-click Local Area Connection

16 Enter 192.168.1.100 into the IP address field, 255.255.255.0 into the Subnet mask field Click OK Select Use the following DNS server ad

Technical Support  For more troubleshooting help, go to: www.tp-link.com/support/faq.asp  To download the latest Firmware, Driver, Utility and U

2 Locate a suitable mounting site for your CPE. For choosing the best location, select an elevated location where trees, buildings and large s

3 The connection will be similar to the figure below after the above steps are finished. Turn on all your network devices and then check to see

4 Login A dialog box will prompt you for the User name and Password.Enter the default values and click OK. Note If the dialog box does no

5 Operation Mode Setting 2 A. Configuration for WISP Client (CPE) This page will then display. The AP supports three operation modes:

6 B. Configuration for Point-to-Point Connection 1) The AP Setting Click Finish to exit the Quick Setupwizard and wait until the AP compl

7 2) The Client Setting After your successful login, please configure the other TL-WA7510N by following the steps below. Click

8 C. Configuration for Repeater This page will then display. Select Repeater Click Search Click Wireless > Wireless Settings Find the BSSI

9 Antenna Alignment The BSSID is the same as the MAC address. Note After basic configuration of operationmode, you can adjust your CPE’s directi