TP-LINK TD-8816 V7 Guide d'installation télécharger pdf (Page 2)

Turn on all of your network devices, including your computer and the Modem

Router then check to see if the LEDs of the Modem Router display normally as

the diagram below describes.

If the LEDs display abnormally, please check to see if all the cable connectors

(power adapter, phone line and Ethernet cable) are well connected to your

device. With the phone line well connected, if the ADSL LED turns off after a

quick-flash, please contact your ISP to ensure that your internet connection is

active.

Note

To configure the device, you can either run the setup CD-ROM (method one),

or run the Web based Quick Setup Wizard (method two). TP-LINK strongly

recommends that you run the setup CD-ROM.

If no telephone is needed, please connect the LINE port of the Modem

Router to the wall jack using the telephone line directly.

Note

Power: Solid light

LAN: Solid light if LAN

port is connected

ADSL: Flashing when the modem

is synchronizing; Solid light if the

modem is synchronized

1 2 3 4 5 6 7 ... 17 18

Pas de commentaire

TP-LINK TD-8816 V7 Guide d'installation Page 2