TP-LINK TL-WR940N V1 Guide d'installation télécharger pdf (Page 2)

WAN: Flashing or solid light

Turn on all of your network devices and then check to see if the LEDs of the

Router display normally as the digram below describes.

Note

To configure the device, you can either run the Resource CD (method one),

or run the Web-based Quick Setup Wizard (method two). TP-LINK strongly

recommends that you run the Resource CD.

LAN: Flashing or solid light if the

corresponding port is connected

Note

If the LEDs display abnormally, please check to see if all the cable

connectors (power adapter and Ethernet cable) are well connected to you

device.

SYS/WLAN: Flashing

PWR: Solid light

1 2 3 4 5 6 7 ... 18 19

Pas de commentaire

TP-LINK TL-WR940N V1 Guide d'installation Page 2