TP-LINK EAP220 Guide de l'utilisateur télécharger pdf (Page 14)

Chapter 2 Network Topology

A typical network topology for the EAP is shown below.

Figure 2-1 Typical Topology

To deploy an EAP in your local network, a DHCP server is required to assign IP addresses to the

EAP and clients. Typically, a router acts as the DHCP server. Ensure the EAPs are in the same

subnet with the Controller Host in which the EAP Controller is installed.

The EAP can be managed by the EAP Controller software, which is a management software

specially designed for the TP-LINK EAP devices on a local wireless network, allowing you to

centrally configure and monitor mass EAP devices using a web browser on your PC. For more

information about the EAP Controller, please refer to the EAP Controller User Guide in the

resource CD or download it from our official website:

http://www.tp-link.com/en/support/download/

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 69 70

Pas de commentaire

TP-LINK EAP220 Guide de l'utilisateur Page 14