TP-LINK TL-SG5428 Guide de l'utilisateur télécharger pdf (Page 169)

156

Example

Create a MAC ACL whose ID is 23:

TL-SG5428(config)# mac access-list 23

access-list standard

Description

The access-list standard command is used to add Standard-IP ACL rule. To

delete the corresponding rule, please use no access-list standard command.

Standard-IP ACLs analyze and process data packets based on a series of

match conditions, which can be the source IP addresses and destination IP

addresses carried in the packets.

Syntax

access-list standard acl-id rule rule-id { deny | permit } [ sip source-ip smask

source-ip-mask] [ dip destination-ip dmask destination-ip-mask ] [ tseg

time-segment ]

no access-list standard acl-id rule rule-id

Parameter

acl-id —— The desired Standard-IP ACL for configuration.

rule-id —— The rule ID.

deny —— The operation to discard packets.

permit ——The operation to forward packets. It is the default value.

source-ip —— The source IP address contained in the rule.

source-ip-mask —— The source IP address mask. It is required if you typed

the source IP address.

destination-ip —— The destination IP address contained in the rule.

destination-ip-mask —— The destination IP address mask. It is required if you

typed the destination IP address.

time-segment —— The time-range for the rule to take effect. By default, it is

not limited.

Command Mode

Global Configuration Mode

Example

Create a Standard-IP ACL whose ID is 120, and add Rule 10 for it. In the rule,

the source IP address is 192.168.0.100, the source IP address mask is

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 238 239

Pas de commentaire

TP-LINK TL-SG5428 Guide de l'utilisateur Page 169